# After clip using vtkClipPolyData, stll remain faces

**URL:** https://discourse.vtk.org/t/after-clip-using-vtkclippolydata-stll-remain-faces/7830
**Category:** Development
**Created:** [February 13, 2022, 10:44am UTC](https://discourse.vtk.org/t/after-clip-using-vtkclippolydata-stll-remain-faces/7830 "2022-02-13T10:44:12Z")
**Posts on this page:** 1
**Showing post:** 3

<div class="post-metadata">

### Author: ![feierpusier](https://discourse.vtk.org/letter_avatar_proxy/v4/letter/f/c5a1d2/32.png) [@feierpusier](https://discourse.vtk.org/u/feierpusier)
#### Post date: [February 14, 2022, 12:02pm UTC](https://discourse.vtk.org/t/after-clip-using-vtkclippolydata-stll-remain-faces/7830/3 "2022-02-14T12:02:10Z")

</div>

It is my fault. My question is similar to [Clipping an stl with a cylinder - #5 by dgobbi](https://discourse.vtk.org/t/clipping-an-stl-with-a-cylinder/2012/5) . I found this page just now.

---

_[View the full topic](https://discourse.vtk.org/t/after-clip-using-vtkclippolydata-stll-remain-faces/7830)._